References

2017. Replacement of internals of Fluid catalitic cracking  main  fractionator K-201 at oil-processing plant AB ORLEN Lietuva



2016. Manufacture, delivery and installation of the smoke channels, pipes boiler pipeline,  samples cooling pipes, furnace cooling pipeline and compressed air pipes for the new boiler in Visaginas (Lithuania)

Customer: JSC Enerstena



 

2016-2017 Analysis of the Final Decommissioning Plan of Ignalina Nuclear Power Plant
Customer: Radioactive waste management agency
Service provider: Partnership consisting of JSC „Svertas“ (leading partner) and   Empresarios Agrupados Internacional S.A. (Spain)
Scope of works under the project:
The purpose of this contract is to provide independent analysis of Ignalina NPP final decommissioning plan  (INPP FDP) Issue 07 and analysis of the Megaproject Schedule.
Based on INPP FDP and Megaproject schedule analyses, identification of areas for efficiency improvement for INPP FDP and Megaproject schedule (in terms of budget and implementation deadlines) and identification of actions for the fulfillment of the improvements will be implemented


2015-2016 Review of design documentation of low and intermediate level short lived radioactive waste repository  (В-25)
Customer: Central Project Management Agency
Assistance receiver: State Nuclear Power Safety Inspectorate (VATESI)
Scope of works under the project:
Purpose of this project – to provide State Nuclear Power Safety Inspectorate (VATESI), Lithuanian  the nuclear safety regulatory authority with technical and scientific support reviewing design documentation of the Repository, for which the customer is Ignalina Nuclear Power Plant (henceforth INPP), submit comments, recommendations and conclusions on the Repository design solutions provided in the design documentation compliance with safety requirements established in Lithuanian legislation and International Atomic Energy Agency safety standards for repository of this type, so that VATESI, on the basis of recommendations and conclusions by the Provider, could take a decision on the issuing of a construction licence for the Repository to INPP.


2014-2017. Provision of technical support, modification and configuration services for Ignalina NPP Free Release Measurement Facility software.
Contractor: Svertas – VF a.s. (Czech Republic)
Employer: SE Ignalina Nuclear Power Plant (Lithuania)
Scope of works under the project:
Provision of consulting services to the Employer on the issues related to the software operation, analysis of problems and elimination of detected software operation errors, as well as modification and configuration of the existing software according to the Employer`s demands.



 

2015. Supply, pre-commissioning and commissioning of Е135-3,2-420 boiler automation set for the Northern Power Plant VKG Energia OU (Kohtla-Jarve, Estonia)
Employer: LLC "Belenergomash-BZEM"



 

2015. Development of repair technologies and repair of HPC turbine К-300-240-1 of unit No. 8 of Lithuanian HPP.
Employer: PLLC “Lietuvos energijos gamyba”(Elektrėnai, Lithuania)
Scope of works under the project:
The following works were performed within the framework of the Project: development of technologies for repair of cracks in HPC body wall, development of control program aimed for assessment of strength and technological properties of metal in the damaged area and sampling for fractographic studies, estimated optimization of HPC body repair welding sequence (using ANSYS software) aimed for prevention of coupling deformation after repair, study of reasons of crack occurrence in HPC body, welding of HPC body according to the developed repair technology, submission of report on safe life according to the work results and non-destructive test data.


 

2014-2015. Assessment of technical condition of steam turbines of Lithuanian Power Plant unit 7 and 8 and issuing of report on extension of life cycle of the turbines.
Employer: PLLC “Lietuvos energijos gamyba”(Elektrėnai, Lithuania)
Scope of works under the project:
Development of turbine technical diagnostics program, analysis and assessment of operational modes and data collected during the technical diagnostics, submission of report on technical conditions of turbines and issuing of report on extension of life cycle of the turbines.


 

2013-2014. Designing, manufacturing, supply and commissioning of Ignalina NPP G-1 cell turbine hall equipment fragmentation and decontamination facility.

Contractor: Partnership of companies: KER –Svertas -Ekobana

Employer:   SE Ignalina Nuclear Power Plant (Lithuania)

Scope of works under the project:

Technical and Detailed Designs were developed within the framework of the Project: fragmentation cell, wet and dry decontamination cell, special ventilation system for radioactive contamination treatment.

The following equipment was manufactured, supplied and commissioned within the framework of the Project: fragmentation and decontamination cell, lifting equipment, automatic blast cleaning equipment, vessel rotator, ventilation equipment with HEPA filtration system. Training of the Employer`s personnel was held.

After implementation of the Project Ignalina NPP initiated G1 cell equipment decommissioning and decontamination operations.



2010 – 2014. Installation of ball cleaning system for turbine condenser tubes from the units of Estonian Power Plant.
Employer: Eesti Energia (Narva, Estonia)
Scope of works under the project:
Within the framework of the Project we developed the design for equipment installation, supplied and erected the equipment, carried out pre-commissioning operations, held training and commissioned the ball cleaning system for condenser tubes with preliminary water treatment filters compatible with the existing cooling system.



2014. Installation of ball cleaning system for line heaters at Riga CHP-2.
Contractor: SIA Energoremonts Riga - Svertas
Employer: AS Latvenergo (Riga, Latvia)
Scope of works under the project:
Within the framework of the Project we developed the design for equipment installation, manufactured, supplied and erected the equipment, carried out pre-commissioning operations, held training and commissioned the ball cleaning system for line heaters.


2014-2015. Modification and overhaul repair of condensation turbine No. 3 of VKG Energija OU.
Employer: VKG Energia OU (Kohtla-Jarve, Estonia)
Contractor: Ekol energo s.r.o. – Svertas
Scope of works under the project:
Turbine dismantling, manufacturing and total replacement of rotor and stator blades, turbine body repair, regulation system repair, repair of cut-off valves, foundation, turbine installation and commissioning.


2013-2014. Designing and reconstruction of Narva portable water treatment plant.
Employer: Narva Vesi, AS Merko Ehitus (Narva, Estonia)
Scope of works under the project:
Designing, supply, installation, training of personnel and commissioning of TAPIS bottom intake system.


2014. Overhaul repair of П6-35/5M turbine of Kivioli Keemiatoostuse OU, Estonia.

 

2014. Non-destructive testing of Lithuanian HPP К-300-240-1 turbine components (rotors, etc.).

 

2012. Overhaul repair of unit No. 3 ТВВ-300-2У3 turbine generator at “Kardia” CHP, Greece.

 

2012. Designing and installation of heat supply system for Spent Nuclear Fuel Storage Facility (SFSF) at Ignalina NPP.



2010. Designing and installation of heating line to the Low Level Radioactive Waste Storage Facility at Ignalina NPP.

 

2011. Designing and development of project for manufacturing of special lifting equipment designed for dismantling of ECS hydraulic cylinders in building 117/1 at Ignalina NPP.

 

2010. Reconstruction of 6/0.4kV transformer substation in building 130/1 at Ignalina NPP.